ADTRAN Network Card 850 DSX 1 User Manual

For more detailed documentation, visit us online at www.adtran.com  
Total Access 850 DSX-1 Module  
P/N 1200385L1  
Quick Start Guide  
The Total Access 850 DSX-1 Module is for use with the Router Controller Unit (RCU) only. This module provides data support (no  
RBS for voice applications) for Customer Premises Equipment (CPE) and CANNOT be connected to network resources; this  
module is for connection to CPE only.  
DSX-1  
1200385L1  
SPECIFICATIONS  
DSX-1 CONNECTION PINOUT  
STATUS  
Capacity  
T1: 1 to 24 DS0s  
Pin  
Name  
Description  
Framing  
ESF and SF (D4)  
1
R1 | RXDATA-RING Receive data from the network  
(RING)  
Line Build Out  
Line Coding  
DSX-1: 0 to 655 feet in 133-ft increments  
2
3
4
T1 | RXDATA-TIP  
UNUSED  
Receive data from the network (TIP)  
–––  
AMI (alternate mark inversion) or B8ZS (bipolar 8  
zero substitution)  
Line Rate  
1.544 Mbps ± 75 bps  
R | TXDATA-RING  
Transmit data towards the network  
(RING)  
Terminating  
Impedance  
100 ± 5%  
5
T | TXDATA-TIP  
UNUSED  
Transmit data towards the network  
(TIP)  
Tests  
Self-test, local line, local payload, remote line,  
and remote payload  
6-8  
–––  
Environmental  
Operating Temperature: 0° C to 50° C  
Storage Temperature: -40° C to +70° C  
Relative Humidity: Up to 95% noncondensing  
INSTALLATION INSTRUCTIONS  
1. Remove the cover plate from the appropriate slot of the  
Total Access 850 chassis.  
LED DESCRIPTIONS  
Color  
OFF  
Description  
Dangerous voltage is exposed when the  
cover plate is removed.  
No power to the system  
GREEN  
DSX-1 signal is present and synchronized; the  
DSX-1 channels are configured for use  
2. Position the module to fit in the lower and upper grooves.  
RED  
Active channel alarm on the DSX-1 interface  
Channel test in progress  
3. Slide the module into the option slot, pressing equally on the  
top and bottom of the faceplate until the module is firmly  
positioned against the back of the chassis.  
Solid AMBER  
Blinking AMBER  
Module is initializing (during startup)  
4. Push in the ejector on the lower left-hand side of the module  
to finish seating the module.  
Quick Start Guide, 61200385L1-13A, September 2004  
Technical Support 1-888-4ADTRAN (1-888-423-8726)  
© 2004 ADTRAN, All Rights Reserved  
 

Acer Laptop 3400LMI User Manual
AEG Washer L 1045 E User Manual
Agilent Technologies Laptop 81200 User Manual
Air King Ventilation Hood DRLC User Manual
Airlink101 Switch AGSW1600 User Manual
Alps Electric Switch SSCM Series User Manual
AVerMedia Technologies Network Card NV6240EXPRESS 8CH User Manual
Axxess Interface Cell Phone ABTI GM4 User Manual
Beko Air Conditioner LG BKE 6450 D LG BKE 6500 D User Manual
Beko Ventilation Hood CWB 9601 X User Manual