Instruction Manual
3-in-1 Sensor Wind Cups
model 11146-3N1WC
Step 1:
To remove old or broken wind cups from the
sensor, secure fingers between the wind cups.
Then, pull base of wind cup assembly away
from the sensor while securing the sensor with
your free hand. Tip: Hold the sensor close to
your body to maximize pulling strength.
Caution: Broken edges of wind cup may be
sharp.
Step 2:
Line up the mounting hole on the replacement
wind cups with the spindle on the sensor.
Tip: Place one drop of light machine oil or
spray lubricant on the spindle to ensure the
anemometer will spin freely.
Step 3:
Attach the wind cups by inserting the
spindle onto the sensor. Apply pressure
to ensure the wind cups are properly secured
on the sensor.
Questions? Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com
SAVE THIS MANUAL FOR FUTURE REFERENCE.
|