ONE YEAR WARRANTY
AllerAir units in this series are covered by one-year warranty against defects
in materials and workmanship for a period of one year from the date of
purchase. Warranties are limited to the original purchaser and are thus
non-transferrable.
Operation and Maintenance Manual
Units must be shipped back to AllerAir in their original packaging. Clients are
responsible for insuring packages with carriers such as UPS.
The warranty does not cover expendable parts such as filters and pre-filters.
AllerAir Industries Inc. is not liable for any consequential damages for breach
of this or any other warranty expressed or implied whatsoever.
One year parts and labor.
AllerAir top quality air purification machines are distributed worldwide
for commercial, residential, institutional and industrial use. The units
employ cutting-edge technology, and are built according to the highest
standards required for health and safety.
8000 Series
Air Purifiers
A8PK7025
Model #
Serial #
Congratulations! You're moments away from fresher, cleaner
indoor air. Your new AllerAir unit will combat many of the chemicals, gases,
odors and particles responsible for poor indoor air quality (IAQ). Poor IAQ
may cause or worsen allergies, asthma, multiple chemical sensitivities (MCS)
and sick building syndrome. We recommend proper maintenance of your unit
to keep it running efficiently for years to come.
Operation:
All units except D and DX models are shipped fully assembled and ready for
use. (D and DX model owners may refer to their additional instruction sheet
for filter installation, or refer to Page 3 of this booklet.)
NOTE: As original packaging is required for warranty returns, new AllerAir
owners are advised to keep boxes and shipping materials.
8
July/23/2007
AllerAir Industries Inc.
AllerAir Industries Inc.Toll free:1-888-852-8247 / Fax:1-877-68D8o-2w1n9lo3adwfrwomw.Wallwewra.Siro.cmomanuals.com. All MaAnullaelsrASieraIrncdhuAsntdriDeoswInnlco.aTdo.ll free:1-888-852-8247 / Fax:1-877-688-2193 www.allerair.com
HEPA & CARBON FILTERS ORDER GUIDE
REFILING THE CARBON CANISTER
Your AllerAir unit contains two filters.The carbon filter is the smaller, innermost one.
Tools required:
Philips screwdriver, garbage bag large enough to hold all of the old carbon, rubber m
These replacement filters will extend the life of your AllerAir unit. Please be sure
to follow the instructions for changing the filters in your unit.
We recommend changing pre-filters every two months, HEPA filters every
three to five years, and carbon filters every two years.
* Please note that this is a messy, dust-producing job, so select attire and site for the task accordingly.
AllerAir makes a special funnel to evenly refill carbon filters.
Call 1-888-852-8247 during regular business hours (EST) or e-mail to order.
Order Reference Numbers
Please use the numbers in the chart when placing your order.
Call AllerAir at 1-888-852-8247 during regular business hours (EST)
or send an e-mail to [email protected]
HEPA Filter Order Guide
8000
A8FH0411
Models
Exec, Vocarb
STEP 1
STEP 2
STEP 3
Remove the carbon filter from
the unit by pressing thumbs
against the inner rim and pulling up.
Gently pull back the pre-filter to
access the four screws at the top
of the filter. Remove the screws with adequate size and tie the
Discard all of the old carbon.
Pour it into a garbage bag of
NOTE: Please use the above part numbers when ordering your replacement parts
a Philips screwdriver and take off
the lid of the filter.
bag shut.
Microparticulate Electrostatic Filter Order Guide
8000
Models
D Models
DX Models
DS Models
A8FMR002
STEP 4
STEP 5
STEP 6
Pour in the new carbon, using a
funnel if desired. As you pour, tap
the sides of the filter with the rubber and gently slide the filter back into
mallet to help settle the carbon
granules.
When the filter is full, replace the lid Replace the felt gasket.
NOTE: Please use the above part numbers when ordering your replacement parts
This is the filter that wraps around any D, DX, DS or MCS carbon filter.
and its screws. Adjust the pre-filter,
Replace the base of the unit.
Align the arrow on the base's
gold sticker with the unit's seam,
and replace the four screws with
a Philips screwdriver.
the unit.
Replacement Carbon Filter Order Guide*
Order Reference Numbers
Empty Carbon Canisters Order Guide*
Models
8000
8000
Notes
Models
Exec Models 2.5"**
Vocarb Models 2.5"**
D Exec Models 3"
D Vocarb Models 3"
DX Exec Models 3.5"
DX Vocarb Models 3.5"
DS Models 3"
A8FCB325
A8FCB225
A8FCB330
A8FCB230
A8FCB335
A8FCB235
2.5" Canister**
D Models
DX Models
A8FC1501
A8FC0503
A8FC1503
Exec and Vocarb models
*Please use the above part numbers when ordering your replacement parts.
*Please consult the Bulk Carbon Order Guide
*Please refer to your carbon filter depth when ordering a replacement
Bulk Carbon Order Guide*
4000
AM000911
AM000912
Models
Exec Mix
Vocarb Mix
Notes
*Please use the above part numbers when ordering your replacement parts.
If you have ordered a special blend of carbon in the past please let us know about it when ordering the
replacement
Tobacco Smoke MixAM000901
**Please refer to your carbon filter depth when ordering a replacement
Special Blend Mix
*Please use the above part numbers when ordering your replacement parts
please call
4
5
|