Installation
Instructions
7010.190
GREEN TEA ACCESSORIES
7010.210
7010.211
7010.230
TOWEL RING
ROBE HOOK
DOUBLE ROBE HOOK
TISSUE HOLDER
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read instructions carefully before you begin.
Certified to comply with ANSI A112.18.1
M968630 Rev. 1.1
Recommended Tools
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
Regular Screwdriver
10'
Drill
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
Tape Measure
Phillips Screwdriver
TOWEL RING, ROBE HOOK and TISSUE HOLDER
MOUNTING BRACKET INSTALLATION
1
The TOWEL RING, ROBE HOOK and TISSUE HOLDER work best if secured to a wall stud or cross brace within the wall, using 1-1/2"
long SCREWS (3) not supplioed.
If the TOWEL RING, ROBE HOOK and TISSUE HOLDER are to be installed on a tile or plaster wall the ANCHORS (4) and SCREWS (2)
should be used.
Determine desired height and location (optional) for the accessory and mark a center line. If MOUNTING BRACKET (1) is secured to a
stud or cross brace drill small pilot holes for SCREWS (3). (NOTE PROPER POSITION OF MOUNTING BRACKET FOR ACCESSORY
TO BE INSTALLED.}
For installations on drywall or tiled walls, use ANCHORS (4) and SCREWS (2) for securing MOUNTING BRACKETS (1) to wall. Use MOUNTING
BRACKET (1) as a template and mark the mounting holes. Drill three 1/8" diameter holes a minimum of 1-1/4" deep. Insert the three
ANCHORS (4) flush with face of the finished wall.
Secure MOUNTING PLATES (1) to wall with SCREWS (2).
LEVEL
1-1/2"
1
CENTER
LINE
2
3
POSITION OF
MOUNTING BRACKET
FOR TOWEL RING
AND ROBE HOOK
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
4
1/8" DIA. HOLES FOR
ANCHORS (4)
POSITION OF MOUNTING
BRACKET FOR DOUBLE ROBE
HOOK AND TISSUE HOLDER
|