EIR618 Series-5107qsg
Quick Start Guide
3
4
LED Chart
Hardware Installation
Elinx Managed Ethernet Switch
EIR618 Series
o
Record the switch’s MAC Address in the space
provided. The MAC Address is printed on the product
label. NOTE: Provide the MAC Address to your
Network Administrator. The Network Administrator
should provide an IP Address, Subnet Mask, and
Gateway.
Select a mounting location and install with the attached
DIN rail clip or included panel mount kit.
Connect power to the switch
LED
Status
Green
Off
Green
Off
Green
Off
Red
Meaning
The Switch is powered on
The Switch is powered off
Power Source 1 is available
Power Source 1 is unavailable
Power Source 2 is available
Power source 2 is unavailable
Power or Port failure
Normal Operation
The Switch is the master of a redundant
ring (X-Ring)
The Switch is not the master of a
redundant ring.
SFP Port is linked
Data is being transmitted or received
Not connected to the network
Port is linked
Data is being transmitted or received
Not connected to the network
Operating at 1000M
PWR
PWR1
PWR2
Fault
o
o
Off
o
o
12 to 48 VDC
Redundant inputs are available with fault
contacts.
Green
Off
R.M
NOTE: The installation of an SFP Module disables
the associated RJ-45 Port.
Green
Blinking
Off
Green
Blinking
Off
Green
Off
Green
Blinking
Off
LINK/ACT
Port 17/18*
SFP
T
T
T
B
B
T
T
T
B
B
B
1
Log into the Switch
Items Included
Port
17/18*
RJ-45
5
Disconnected or below 1000M
Connected to the network
Data is being transmitted or received
Not connected to the network
Operating in full-duplex
o
o
These instructions are for Web based management.
Refer to the User’s Manual for instructions concerning
console management.
Connect a switch port to a stand alone PC. Change the
PC’s network IP Address to allow it to connect to the
switch (ex: 192.168.16.2). Use the default subnet mask
and gateway.
o
Ethernet Switch
o
o
o
o
Console Cable (RS-232 RJ-45 to DB-9)
CD with Support Manual
This Quick Start Guide
Panel Mount Bracket
P1-16*
Yellow
Blinking
Off
Data collision
Half-duplex or not connected
o
o
Launch the PC’s web browser and navigate to the
switch by typing the switch’s IP Address in the browser
address window.
Navigate the web page by expanding the folders on the
left side of the web page.
Ports 1 through 16 are 10/100 RJ-45, Ports 16 & 17 are
100/1000 RJ-45 or SFP.
*Note
Default Settings
2
o
o
o
o
IP Address: 192.168.16.1
Subnet Mask: 255.255.255.0
Gateway: 192.168.16.254
User Name: root, Password: root
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland
+353 91 792444 Fax +353 91 792445
|