KH 391
=
=
M
F
Body Fat and Water Level Analyzer KH 391
Thank you for purchasing our Body Fat and Water Level Analyzer. This handy appliance will help
you to control your body – anytime and anywhere. Weight is not the proper indicator for health and
fitness. It is much more important to know what weight is composed of. Too high body fat rates can
result in serious diseases as diabetes, hypertension or heart disease. Too low body fat rates can
lead to deficiency symptoms hence body fat saves vitamins and energy for times of need. Furthermore
it protects inner organs and regulates body temperature.
Body fat rate varies depending on age and sex. Following table shows how much body fat is regarded
as healthy:
Body Fat Rate (%)
Women
Normal High
Men
Normal High
Age
Low
Low
20-24
25-29
30-34
35-39
40-44
45-49
50-59
>60
18-22
19-22
20-23
21-24
23-26
24-27
27-30
28-31
22-25
22-26
23-27
24-28
26-30
27-31
30-33
31-34
25-30
26-30
27-31
28-31
30-33
31-35
33-36
34-38
11-15
12-17
14-18
16-20
17-21
18-22
20-23
20-23
15-19
17-21
18-22
20-23
21-24
22-25
23-26
23-26
19-24
21-25
22-25
23-26
24-27
25-28
26-29
26-30
4
Depending on the age, human body exists till 80% of water (see table below). Water serves important
metabolism functions: it regulates body temperature and transports nutrients between cells and
organs. Since body loses water all the time, water must be replaced to save from water deficiency,
which causes a concentration of toxins in body. It can even be life-threatening if human body loses
more than 20% of its average water content.
Water content
Baby 1st day
80%
70%
60%
50%
Baby 3rd month
Adult 25 years
Adult 85 years
Bioelectric Impedance Analysis (BIA)
Our handy Body Fat and Water Level Analyzer is working with the BIA technology. This means that
a low, non-noticeable and absolute innocuous voltage is conducted through the body. Then the
impedance (resistance) the voltage meets on its way through the body is being measured. The more
muscles the body has, the more water it contents and the voltage can easily pass the body. The
more fat the body has, the bigger the resistance is that the voltage meets on its way through the
body. On the basis of measured impedance and personal settings (height, weight, sex, age), the
body fat and water content will be analyzed within a few seconds. 10 memories per user allow
watching the results over a longer period.
Before using this product, be sure to read the following instructions.
5
Do not make measurements in any of the following situations because water content in the body
tends to fluctuate, which will affect the measurement.
After agitated exercises
After taking shower
After drinking alcoholic beverage
After drinking water or eating (Within 1 ~2 hours)
The following population may experience dramatic changes in the difference between average water
content and bone density, resulting in measurement error, i.e. the measurement might deviate
significantly from actual body fat ratio.
Children
Senior females in menopause
Athletes and gymnasts
People suffering from flue and fever
People with swollen feet
People suffering from osteoporosis
Pregnant women
People needing renal analysis
People with cardiac pacemaker or other electronic implants and children younger then 10 years or
smaller than 100 cm are not allowed to use the appliance.
6
Product's description
(1) Electrode
(2) MODE Button:
To change the selection
Time mode
Body Fat mode
Alarm mode
(3) SET Button:
Time setting
Setting user's basic information
Start measuring body fat
Setting alarm time
(4)
(5)
Button:
Increase setting value
Switch user body fat mode
Alarm on/off mode
Button:
Decrease setting value
Body Fat mode, Browse antecedent
(6) LCD Display as figures
Operation mode
(1) Time (2) Body fat meter (3) Alarm mode switch
7
(1) Time mode
Time setting:
Hold SET for about 2 seconds to enter into Time Mode and set the 12 -24 Hour Mode. To change
this mode, press the
To set hours, press
minute setting. To set minutes, press
and reset second.
/
key. After the setting, press SET to save and enter into the hours setting.
to change hour. After the setting, press SET to save and enter into the
/
/
to change minute. After the setting, press SET to save
(2) Body fat meter mode
In Time Mode, press MODE once to enter into the body fat meter mode.
Select user:
By pressing the UP key, you may switch to USER0, 1,…,10.
USER 0: This is a Guest (unspecific user) and the data and measurement value are not memorized.
USER 1 to 10: The basic information will be memorized and the measurement value is memorized
too (10 groups).
Setting user's basic information:
Select user (USER 0 to 10) and then press SET for 2 seconds to enter into setting mode for weight
(Fig1), height (Fig2), sex (Fig3) and age (Fig4) that go flashing. Use the
/
key to change setting.
After each setting, press SET to enter into the following, until successful setting (USER1 to10 will
memorize all basic information as set).
8
Body fat measurement:
Select user USER0 to 10 and then press SET (for less than 1 second) and you are in Standby Mode
(Fig5).
By following the instructions given in Fig.6 and Fig.7, measurement starts when you have both hands
touch the electric panel. The result will be displayed in about 5 seconds. Please refer the Fig. 8 for
fat rate and water level as Fig. 9. Both data will flash alternatively every 2 seconds.
If would like to recall previous data , press
button to fix user (USER 1 to 10 ) then press
button,
you may know your stored memory In the device. See Fig10 and Fig. 11 performed by LCD display
alternatively. If all 10 memories are full, the oldest data will be replaced.
(3) Alarm clock mode
Start Alarm Mode:
press
button you may select to open or close alarm.
How to set up alarm:
In Time Mode press MODE twice to enter into the Alarm Mode. Hold SET button for 2 seconds, to
enter hour setting. To set hours, press
/
to change hour. After the setting, press SET to enter
minute setting. Press
/
to change minute and press SET to save the settings.
9
Declaration of conformance
We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, declare this
appliance to be in conformance with all applicable international standards, safety requirements and
the EC Directives.
No. of appliance/Type: KH 391
Bochum, 31.10.2002
Hans Kompernaß
- Manager -
10
|