PSA-24 Power Supplies (24 Volt)
Features
• 24V dc power supply delivers up to 2.2 amps to power Banner 24V continuous LED
lights
• Choose model with 120V ac North American power cord, or with 220V ac Euro
power cord
• Includes pre-wired 9-pin D-sub connector for direct connection to LED lights
• Tough ABS housing
PSA-24 Models
Input
Cord
Output
Cable
Models
Input
Output
Used with
Connections
100-250V ac
50/60 Hz
1.8 m (6')
North America
(NEMA 5-15)
PSA-24†
24V dc 5%
with voltage
regulation of 1%
2.2 A max.
Pin 6 = +V
Pin 7 = +V
Pin 8 = dc common
Pin 9 = dc common
Terminated with
9-pin D-sub
connector
Continuous
LED lights
1.0A (RMS) for 120V ac
0.5 A (RMS) for 240V ac
Cont. Europe
(Schuko CEE 7)
PSA-24E†
(female pins)
Environmental Rating
Operating Conditions
IEC IP20; NEMA 1
Temperature: 0° to 50°C (+32° to 122°F)
Maximum relative humidity: 95% at 40°C (non-condensing)
86.4 mm
(3.40")
149.1 mm
(5.87")
1.8 m
(6.0')
50.8 mm
(2.00")
Accessory Extension Cables
Models
Length
Configuration
DB906†
1.8 m (6')
Terminated both ends with 9-pin D-sub connector, for continuous lights
(one end male pins and opposite end female pins)
DB910†
DB9Y†
3.0 m (10')
1.8 m (6') Y cable for powering 2 lights from one supply, for continuous lights
† These models are not stocked and are non-returnable.
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of
charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover
damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
Printed in USA
05/01
P/N 67447
|