C
With the tent secure, drape the fly over the tent body. The fly
only fits on the tent one way. Position the fly over the tent with
the vestibule wing sections over the doors and with the ! section
over the all mesh end of the tent. Reach under the fly and
connect the hook and loop tabs to the tent poles. See fig. 7.
B
ASSEMBLY INSTRUCTIONS
for the DOMINION TENT
Connect the four corner buckles on the fly to their mates on the
tent webs. Do not fully tighten down any of the webs just yet.
See fig 8.
Component List:
1 Tent Body, 2 Tent Poles, 1 Carry Bag,
1 Tent Fly, 1 Stake Bag/ Stakes
D
A
fig. 3
Unroll and unfold the tent with the floor on the ground.
Remove the fly and set it aside. Do not stake the tent down
yet. In windy conditions, we recommend that the mesh end
should face into the wind and that you stake down one
corner of this end.
Start at the front of the tent at
grasp the end of the pole in one hand
and the web loop in the other. Push
D,
the pole from
Insert the pin into the pole ferrule to
maintain tension across the seam line.
Repeat with the other pole;
See fig. 3 and 4.
D
to
B
creating an arc.
Join the shockcorded poles. Try to prevent pole sections
from snapping together, as this can damage the pole ends.
NOTE: Make certain each insert end has seated firmly into
each plain end.
fig.7
fig.8
C
to
A.
fig. 4
At the front of the tent, pull the stake out loop on the vestibule
taut and stake it down. Make sure that the vestibule is tight
across the door. Repeat with the other vestibule at the rear of
the tent.
Raise up the tent poles and attach the peak of the tent to
them. Capture both poles where they cross, with the top
tent clips. Then attach all remaining clips to the poles.
C
B
See fig.9.
Your tent is now free-standing,
place it in location that has enough
room for the fly and stake it down
through the corner rings. Stake the
opposite corners while applying
tension to smooth the floor
D
wrinkles. NOTE: General purpose
stakes are included but snow or
fig. 1
A
fig. 5
sand stakes can be purchased at a
Eureka! dealer.
See fig 5 and 6.
At the front corner of the
tent- A, slide the ball end of
one of the aluminum poles
into the rod sleeve. Angle
the pole to the opposite
fig. 6
fig.9
With the vestibule wing sections staked down and tight, go to
the open side of the tent, pull out the vent and hold in place
with the hook and loop tab. Then adjust and tighten all the
remaining side release buckles.
corner;
repeat with the second pole
and sleeve; to
See fig. 1 and 2.
A
to
C
. At corner
B,
B
D.
Your tent is now ready for use.
fig. 2
NOTE:
In strong winds, tie extra guy lines to the storm loops on the
fly and stake down so that the lines are tight.
REV B 4.09
|