Safety information
Warranty
• For use in dry, oil free indoor environments only.
• Do not use to link between buildings.
Adder Technology Ltd warrants that this product
shall be free from defects in workmanship and
materials for a period of two years from the date
of original purchase. If the product should fail to
operate correctly in normal use during the warranty
period, Adder will replace or repair it free of charge.
No liability can be accepted for damage due to
misuse or circumstances outside Adder’s control.
Also Adder will not be responsible for any loss,
damage or injury arising directly or indirectly from
the use of this product. Adder’s total liability under
the terms of this warranty shall in all circumstances
be limited to the replacement value of this product.
If any difficulty is experienced in the installation or
use of this product that you are unable to resolve,
please contact your supplier.
• Not suitable for use in hazardous or explosive
environments or next to highly flammable
materials.
CATX Dual Access Module
Quick Start
(CATX-USBA-DA and CATX-USB-DA)
• Ensure that all twisted pair interconnect cables
are installed in compliance with all applicable
wiring regulations.
The two variants of the CATX Dual Access Module are highly compact devices that allow you to share a single
computer between two sets of peripheral devices. The CATX-USB-DA variant is not fitted with audio or serial
ports but is otherwise identical to the CATX-USBA-DA model.
• Do not connect the CATx link interface (RJ45
style connector) to any other equipment,
particularly network or telecommunications
equipment.
The module connects to various ports on your computer. You then connect it via CAT 5, 5e or 6 cabling to
AdderView CATx KVM switches and/or Adder extender receivers (either AdderLink X2 Silver or X200), each of
which can be located up to 300 metres from the module. Your video displays, keyboard, mice and speakers
are linked to the remote devices.
• Where possible, avoid laying the twisted pair
link cable(s) alongside power cables.
• Do not attempt to service the module yourself.
The CATX Dual Access Module uses a USB port to derive its power from the host computer, dispensing with
the need for a separate power supply and thus simplifying installation.
• The modules do not provide ground isolation
and should not be used for any applications
that require ground isolation or galvanic
isolation.
What’s in the box
*
* Not fitted on
CATX-USB-DA
models
• For correct operation, the transmitter
and receiver modules must have ground
connections. At the computer end, this is
achieved by ensuring that the computer that
the module is connected to has a ground
connection. At the audio/visual device end, this
can be achieved by ensuring that the power
supply is connected to a grounded power
outlet. Alternatively, a ground connection will
be made via the monitor, if the monitor is itself
grounded.
CATX Dual
Access Module
*
What you may additionally need
R
E
W
O
P
L
A
C
O
L
O
T
CAT 5, 5e or 6 link
cables, up to 300m
in length
Adder Technology Limited,
Technology House,
Adder Corporation,
350R Merrimac Street,
Newburyport,
Adder Asia Pacific
m
o
6 New Industrial Road,
Hoe Huat Industrial Building
L
O
C
.c
er
d
d
R
E
.a
M
w
w
O
S
w
D
U
P
G
L
C
Trafalgar Way, Bar Hill,
Cambridge, CB23 8SQ,
United Kingdom
K
P
W
R
w
w
w
MA 01950,
.
a
d
d
e
r
.
#07-01,
Singapore 536199
c
o
m
AdderView CATx
KVM switch
AdderLink X2 Silver or
X200 extender receiver
United States of America
Tel: +1-888-932-3337
Fax: +1-888-275-1117
Tel: +44 (0)1954 780044
Tel: +65 6288 5767
Fax: +65 6284 1150
Fax: +44 (0)1954 780081
© 2011 Adder Technology Ltd • Release 1.0d • June 2011 • Part No. MAN-CATX-USBA-DA-QS-ADDER
All trademarks are acknowledged. Documentation by Corporate Text & Design (www.ctxd.com)
|